ANNUAL or 1000 HOURS
Open the front top right access door and remove
right access cover per TM 5-3895-373-10.
Remove engine access cover per TM 5-3895-
Remove drain plug (1) from drain hose (2) and
drain oil into suitable container. Discard oil in
accordance with local procedures.
Cleaning solvent, P-D-680, Type Ill, is
TOXIC and flammable.
protective goggles and gloves. Use
only in a well ventilated area. Avoid
contact with skin, eyes, and clothes,
and do not breathe vapors. Keep
away from heat or flame.
smoke when using solvent; the
flashpoint for Type III cleaning
solvent is 200F (93,3C). Failure to
do so may result in injury or death to
Clean drain plug (1) using a cleaning cloth and
Hydraulic fitting sealant and pipe
sealant can cause eye damage or
Wash after skin
contact with eyes or skin. If sealant
contacts eyes, flush eyes with water
and get immediate medical attention.
Apply hydraulic fitting sealant to the threads of
Apply pipe sealant to the threads of inspection
drain plug (1) and install into drain hose (2).
plug (4) and filler plug (3).
Remove filler plug (3) and inspection plug (4).
Install inspection plug (4) and filler plug (3).
Slowly pour oil into the filler hole until oil begins
Close front top right access door and install right
to leak out of the inspection hole.
access cover per TM 5-3895-373-10. Install
engine access cover per TM 5-3895-373-20.
Clean filler plug (3) and inspection plug (4) using
a cleaning cloth and cleaning solvent.
Card 25 of 28