TM 5-3895-376-14&P
5-16. GOVERNOR (SPEED) CONTROL SHAFT MAINTENANCE INSTRUCTIONS
This task includes:
a. Adjust
b. Remove
c. Cleaning
d. Inspection
e. Installation
INITIAL SETUP
Tools
Tool Kit, General Mechanics
Caliper, Vernier; item 6, Appx F
Materials/Parts
Solvent, Dry Cleaning; item 9, Appx E
Oil, Lubricating; item 6, Appx E
Gasket (1)
Packing, Preformed (1)
Locking Tab (1)
Lockwasher, M6 (2)
Lockwasher, M8 (1)
Equipment Condition
Compactor set on level ground in protected area.
Engine off.
Oil Drained.
General Safety Instructions
Observe all WARNINGS and CAUTIONS
A D J U S T
NOTE
Adjustment of the governor (speed) control
shaft must be made when the governor
has been repaired and/or the gear cover or
governor (speed) control shaft assembly
has been removed and reinstalled.
1.
If not already removed, remove the two cap-
screws (1), copper washers (2), inspection
cover (3), and gasket (4) from the gear cover.
5-43