TM     5-3895-376-14&P 4-18. THROTTLE CONTROL AND CABLE MAINTENANCE INSTRUCTIONS - Continued 3. Tension on the throttle control (15) may be in- creased by tightening the center pivot locknut. If this does not provide enough friction to hold the control  in  a  constant  positron,  replace  the  control. 4. Inspect threaded fasteners for stripped threads. 5. Replace  any  part  found  defective. 1. Install the connector assembly (16) to the throttle control  (15)  and  tighten  the  jam  nut  securely. 2. Loosen the two setscrews (17) near base of han- dle  on  throttle  control  (15). NOTE The cable assembly (3) has two different end caps on the casing. The end with the longer  stem  is  to  be  Installed  at  the  engine throttle  lever  (18). 3. Pivot the throttle control (15) handle clockwise as far as it will go. Measure a length of the flexible wire  from  the  control  cable  that  will  reach  from the end of the connector assembly (16) into the throttle control (15) and extend approximately 1/2 in. (13 mm ) beyond the two setscrews (17) at base  of  the  control  handle. 4. Grasp the flexible wire just beyond that measured length, and insert the wire through the connector assembly  (16)  and  into  the  throttle  control  until your fingers contact the end of the connector as- sembly. 5. Secure the flexible wire by tightening the two set- screws  (17)  securely. 6. Install  the  throttle  control  (15)  onto  the  guide  bar, securing with two capscrews (13), flat washers (14),  lockwashers  (12),  and  hex  nuts  (11). Tighten   fasteners   securely. 7. Install  clamp  (10)  around  control  cable  (3)  and  se- cure to guide bar with capscrew (7), lockwasher (9), and hex nut (8). Before tightening the fasten- ers, push the control cable casing up tight against the  connector  assembly  (16).  The  stem  of  casing end  cap  should  enter  the  connector  assembly. 4-20 8. 9. 10. 11. 12. Secure casing by tightening the capscrew (7) se- curely. Install  clamp  (6)  around  control  cable  (3)  and  se- cure to stud at air cleaner with flat washer (5) and locknut (4). Ensure that sufficient length of the control  cable  extends  beyond  the  clamp  to  make a  smooth  arch  before  cable  end  enters  the bracket  (19)  on  side  of  engine. Feed  flexible  wire  end  of  control  cable  assembly (3)  through  the  engine  bracket  (19)  and  seat  the stem  of  casing  cap  in  hole  of  bracket. Secure  cable  assembly  (3)  to  bracket  by  install- ing a new triangle lock ring (2), fitting the ring tight against the bottom of the bracket. Insert stem of the stop bolt (1) through the engine throttle lever and feed flexible wire through hole in stop bolt. Adjust  the  throttle  control  cable. 1 . Pivot the throttle control (15) handle to the engine stop  position  (fully  clockwise)  until  mechanical stop  is  encountered. 2 . Manually  place  the  engine  throttle  lever  (18)  in the engine stop (fully down) position. 3. Tighten the screw of the stop bolt (1). locking onto  the  flexible  wire  of  the  control  cable  assem- bly  (3). NOTE Follow-on   tasks   include:   Return   compactor to service.