TM 5-3820-246-14&P
Page
Para
Contents
Lubrication Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cleaning Exterior . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Drain Fuel Tank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..
Section I. LUBRICATION
3-1. LUBRICATION INSTRUCTIONS.
a. General. Keep
all lubricants in
closed containers and store in a
clean, dry place away
from external
heat. Keep
container covers clean and allow no dust, dirt, or other foreign material to mix with lubricants. Keep all lubrication
equipment clean and ready for use.
b. Cleaning. Keep all external parts, not requiring lubrication, free of lubricants. Before lubricating equipment,
wipe all lubrication points free of dirt and grease. Clean all lubrication points after servicing to prevent accumulation
of foreign matter.
c. Lubrication. The Paving Breaker is equipped with a two stroke engine which uses a gas/oil mixture for fuel.
The mixture is a 16:l ratio - 16 parts gasoline to 1 part oil. Use OE/HDO 40, MIL-L-2104 oil (item 7, Appendix E).
Gasoline must be 80 octane or higher and may be leaded or unleaded.
Section II. OPERATOR TROUBLESHOOTING PROCEDURES
a. The troubleshooting System Symptom Index
(Table 3-1) lists common malfunctions which could be
found
during operation of the Paving Breaker. Table 3-2 lists the malfunctions and is followed by a list of tests or inspections
which will help to determine corrective action to be taken. These tests, inspections and corrective actions should be
performed in the order listed. Operation of a deadline unit without a preliminary examination can cause further
damage to a disabled component and possible injury to personnel. By careful inspection and troubleshooting, such
damage and injury can be avoided. In addition, cause of faulty operation of a unit can often be determined without
extensive disassembly.
b. This manual cannot list all malfunctions that may occur, or all tests, inspections, and corrective actions. If a
malfunction is not corrected by the listed corrective actions, notify your supervisor.