TM 5-3895-376-14&P
Section I
Section II
Section III
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
3-1
General
......................................................................................................................
3-2
Detailed Lubrication Instructions ................................................................................
3-3
Introduction........................................................................................................................
3-4
Troubleshooting
Table
..........................................................................................
3-5
Introduction...........................................................................................................................
3-6
Air Cleaner Maintenance Instructions .............................................................
3-7
Fuel Tank Maintenance Instructions .....................................................................
Lubrication Instructions .........................................................................................................
Troubleshooting Procedures ......................................................................................... 3-2
Operator’s Maintenance Procedures .............................................................
Section I. LUBRICATION INSTRUCTIONS
3-1. GENERAL
Operator lubrication requirements on the plate com-
pactor are restricted to checking the engine oil level
and adding oil to bring to top full mark on the dipstick.
3-2. DETAILED LUBRICATION INSTRUCTIONS
a.
Operator should check oil level after operation. If
oil level is at or below the bottom mark on dip-
stick, add clean engine lubricating oil as follows:
b.
Wipe around the oil fill plug (1)
c.
Remove the oil fill plug (1) with a 13 mm open
end wrench.
d.
Fill engine with engine lubricating oil, (Table 4-1).
e.
Check oil level with dipstick (2). Oil level must be
at top mark on dipstick. Add oil as necessary to
bring to top mark.
PAGE
3-1
3-1
3-1
3-2
3-2
3-3
3-3
3-4
3-6
f.
Ensure that the oil fill plug (1) is clean. Install and
tighten the plug firmly to seal gasket.
3-1
