ON-CONDITION or SEMI ANNUAL or 100 HOURS
Start and run engine for five minutes per TM 5-
3895-373-10 before draining oil.
Open the front top left access door and remove
right access cover per TM 5-3895-373-10.
Remove drain hose (1) from hose bracket (2).
Engine oil is hot. Oils can burn when
in contact with very hot surfaces or if
ignited when released as a spray.
Keep ignition sources away. Provide
Remove drain plug (3) and drain oil into suitable
container. Dispose of oil in accordance with
Cleaning solvent, P-D-680, Type ill, is
TOXIC and flammable.
Apply hydraulic fitting sealant to threads of drain
protective goggles and gloves. Use
only in a well ventilated area. Avoid
contact with skin, eyes, and clothes,
Reinstall drain plug (3) and place drain hose (1)
and do not breathe vapors. Keep
into hose bracket (2).
away from heat or flame.
smoke when using solvent; the
Replace engine oil filter per TM 5-3895-373-2 0.
flashpoint for Type III cleaning
solvent is 200F (93,3C). Failure to
Remove oil filler opening cap (4) and refill
do so may result in injury or death to
engine crankcase. Reinstall oil filler opening
Clean drain plug (3) with a cleaning cloth and
Start engine and run at idle speed for three to
five minutes per TM 5-3895-373-10. Check for
Stop the engine per TM 5-3895-373-10. Check
Hydraulic fitting sealant can cause
for leaks. Wait three to five minutes. Remove
eye damage or skin irritation. Wash
dipstick (5) and check engine oil level. Engine
after skin contact.
oil level should be between MIN and MAX marks
on dipstick. Add oil if necessary, but do not
contact with eyes or skin. If sealant
contacts eyes, flush eyes with water
and get immediate medical attention.
Close front top left access door and install right
access cover per TM 5-3895-373-10.
Card 17 of 28