LO 5-3895-373-12
Note 17
ON-CONDITION or SEMI ANNUAL or 100 HOURS
A
Start and run engine for five minutes per TM 5-
3895-373-10 before draining oil.
B
Open the front top left access door and remove
right access cover per TM 5-3895-373-10.
C
Remove drain hose (1) from hose bracket (2).
WARNING
Engine oil is hot. Oils can burn when
in contact with very hot surfaces or if
ignited when released as a spray.
Keep ignition sources away. Provide
adequate
ventilation.
Wear
protective clothing/equipment.
D
Remove drain plug (3) and drain oil into suitable
container. Dispose of oil in accordance with
local procedures.
WARNING
Cleaning solvent, P-D-680, Type ill, is
TOXIC and flammable.
Wear
F
Apply hydraulic fitting sealant to threads of drain
protective goggles and gloves. Use
plug (3).
only in a well ventilated area. Avoid
contact with skin, eyes, and clothes,
G
Reinstall drain plug (3) and place drain hose (1)
and do not breathe vapors. Keep
into hose bracket (2).
away from heat or flame.
Never
smoke when using solvent; the
H
Replace engine oil filter per TM 5-3895-373-2 0.
flashpoint for Type III cleaning
solvent is 200F (93,3C). Failure to
I
Remove oil filler opening cap (4) and refill
do so may result in injury or death to
engine crankcase. Reinstall oil filler opening
personnel.
cap.
E
Clean drain plug (3) with a cleaning cloth and
J
Start engine and run at idle speed for three to
cleaning solvent.
five minutes per TM 5-3895-373-10. Check for
leaks.
WARNING
K
Stop the engine per TM 5-3895-373-10. Check
Hydraulic fitting sealant can cause
for leaks. Wait three to five minutes. Remove
eye damage or skin irritation. Wash
dipstick (5) and check engine oil level. Engine
after skin contact.
Wear safety
oil level should be between MIN and MAX marks
on dipstick. Add oil if necessary, but do not
contact with eyes or skin. If sealant
overfill.
contacts eyes, flush eyes with water
and get immediate medical attention.
L
Close front top left access door and install right
access cover per TM 5-3895-373-10.
Card 17 of 28