TM 5-3820-246-14&P
5-9. COMPRESSOR CYLINDER AND PISTON (CONT).
(4) Install hose joint (14) and valve body
gasket (13).
(5) Install reed valve (12), retainer (11), two
lockwashers (10) and two screws (9). Gap
between reed valve and retainer should be
between 0.0787 in. and 0.098 in. (2.0 mm and
2.5 mm).
(6) Install reed valve (8), retainer (7), two
lockwashers (6), and two screws (5). Gap
between reed valve and retainer should be
between 0.0787 in. and 0.098 in. (2.0 mm and
2.5 mm).
(7) Install compressor valve body (3) on cylinder
head (4).
(8) Install two lockwashers (2) and two
screws (1).
Installation.
e.
(1) Install cylinder gasket (8) and cylinder (5) on
crankcase (6). Align hole on compressor
cylinder with hole on crankcase.
(2) Install head gasket (7) and cylinder head (4)
on compressor cylinder (5).
(3) Install air hose (3) and hose clip (2).
(4) Install four gaskets (1).
NOTE
Follow-on maintenance:
Install carburetor (para 5-10).
Install air cleaner cover (para 4-18).
Install fuel tank (para 4-19).
Install operator handle (para 4-16).
END OF TASK
5-20
