TM 5-3820-246-14&P
This task covers:
c. Assembly
b. Cleaning/Inspection
a. Disassembly
INITIAL SETUP
Materials/Parts
Tools
Lockwashers (4)
Tool Kit, Master Mechanics
Loctite: item 6, Appendix E
Shop Equipment, Automotive Maintenance and
Rag, Wiping: item 8, Appendix E
Repair; Organizational Maintenance, Common
Solvent, dry cleaning: item 9, Appendix E
No. 1, Less Power
Torque wrench
Equipment Condition
Condition Description
TM or Para
Materials/Parts
Front end removed.
Para 4-22
Thrust washer (1)
Air seal (1)
NOTE
If replacing triggers or trigger spring, go to
c. Assembly (4).
a.
Disassembly.
(1) Remove screw and washer assembly (l),
retaining plate (2), and mode selector (3)
from front end (4) using 5 mm socket head
screw key.
Heat may be required to remove screws,
use care not to overheat. Use adequate
hand protection when handling heated
material.
(2) Remove four screws (5) and four
lockwashers (6) using 4 mm key socket
wrench. Discard lockwashers.
(3) Remove stopper plate (7), two balls (8), two
springs (9), rotor (10), and selector pin (11).
(4) Remove spring pin (12) and tool holder (13).
(5) Remove four screws (14) and end plate (15) using 5 mm socket head screw key.
5-28
