TM 5-3895-376-14&P
5-14. GEAR COVER MAINTENANCE INSTRUCTIONS
This task includes:
a. Remove
b. Cleaning
c. Inspection
d. Repair
e. Installation
INITIAL SETUP
Tools
Tool Kit, General Mechanic’s
Hammer, Hand, Plastic; item 16, Appx F
Caliper, Vernier; item 6, Appx F
Press, Arbor (Puller Kit and Press Frame); item 21,
Appx F
Press, Rod; item 53, Appx F
Wrench, Torque; item 50, Appx F
Materials/Parts
Solvent, Dry Cleaning; item 9, Appx E
oil, Lubricating; item 6, Appx E
Gasket, Cover (1)
Gasket, Access Cover (1)
Gasket, Drain Flange (1)
Lockwasher, M5 (2)
Lockwasher, M6 (2)
Equipment Condition
Compactor set on level ground in a protected area.
Engine off.
Oil drained.
General Safety Instructions
Observe all WARNINGS and CAUTIONS
NOTE
3.
Remove the dipstick (Para. 4-16)
Removal of the gear cover may be re-
quired for a variety of reasons. In many
cases not all components mounted on or
in the gear cover will need to be removed
to accomplish a necessary repair or re-
placement. Determine removal needs by
the access required to replace a defective
part. The procedure below provides for
complete removal to replace the gear
cover itself.
4.
Remove the crank handle guide assembly
(Para. 4-20).
5.
Remove the valve cover (Para. 4-33).
6.
Remove the rocker arm assemblies and push
rods (Para. 5-7).
7.
Remove the fuel injector pump (Para. 5-5).
1.
Disconnect the throttle control cable from the
throttle control lever and engine bracket
(Para. 4-18).
2.
Remove the oil filler cap (Para. 4-15).
8.
Remove the compression release (Para. 5-10).
5-37
