TM 5-3895-376-14&P
4-37. FLYWHEEL MAINTENANCE INSTRUCTIONS
This task includes:
a. Remove
b. Cleaning
c. Inspection
d. Installation
INITIAL SETUP
Tools
Tool Kit, General Mechanic’s
Screw, Hex Head Cap (2) (M10x75mm); item 41,
Appx F
Puller Kit; item 36, Appx F
Wrench, Torque; item 49, Appx F
Materials/Parts
Equipment Condition
Conpactor set on level ground in protected area.
V-belt Cover removed.
Clutch removed.
General Safety Instructions
Observe all WARNINGS and CAUTIONS
Solvent, Dry Cleaning; item 9, Appx E
CAUTION
If flywheel is to be removed without dis-
mantling of the governor control link-
age, ensure that the throttle lever is
placed in the FULL LOAD position. Dam-
age may occur to the control linkage If
throttle lever is not at FULL LOAD posi-
tion.
Support flywheel (1) so when it is loos-
ened from the crankshaft the flywheel
will not fall. Damage to flywheel may oc-
cur should it fall.
1.
Install slotted cross block from puller kit over end
of crankshaft and secure to flywheel with two hex
head capscrews (Metric, M10 x 75 mm long) in
two opposed threaded holes in flywheel (1).
Tighten the two capscrews alternately until fly-
wheel breaks loose from the crankshaft. Remove
slotted cross block and capscrews.
2.
Remove the flywheel (1) from crankshaft.
3.
Remove the flywheel key (2) from key slot in ta-
per of crankshaft.
4-68
