TM 5-3895-376-14&P
4-26. CLUTCH ASSEMBLY MAINTENANCE INSTRUCTIONS
This task Includes.
a. Remove
b. Replace Brake Shoes
c. Disassembly
d. Cleaning
e. Inspection
f. Assembly
g. Installation
INITIAL SETUP
Tools
Equipment Condition
Tool Kit, General Mechanic’s
Driver, 12mm Hex Key w/3/4 sq.-dr.; item 8, Appx F
Snap Ring Plier; item 20, Appx F
Wrench, Torque; item 49, Appx F
Wrench, Torque; item 50, Appx F
Materials/Parts
Compactor set on level ground in protected area.
Engine off.
V-belt cover and v-belt removed.
General Safety Instructions
Observe all WARNINGS and CAUTIONS
Solvent, Dry Cleaning; item 9, Appx E
1.
Using a 10 mm hex key, insert key through larger
hex opening in clutch center shaft hub and en-
gage key in hex opening of the inner locking plug.
Turn key counterclockwise to loosen the locking
plug.
2.
The clutch may now be turned by hand or using a
12 mm hex key in opening in center shaft hub, in
a counterclockwise direction to remove the clutch
assembly from the engine crankshaft.
1.
Place the clutch assembly on a clean work sur-
face with the pulley side down.
2.
Remove two screws (1) and outer shield (2).
C A U T I O N
Do not pull on the springs (5) to remove
the brake shoes. Springs will be
stretched and bent rendering them un-
usable.
3.
With a needle nosed pliers, pull the brake
shoes (3) and weights (4) from the assembly.
4-44
