TM 5-3895-376-14&P
5-17. GOVERNOR ASSEMBLY MAINTENANCE INSTRUCTIONS - Continued
in the range of 900 - 1100 rpm, while full load
speed is to be set at approximately 2850 rpm.
9.
Repeat steps 1 through 8, until idle and full load
speed are acceptable.
10. Install the v-belt cover (Para. 4-24).
11. If removed, install the gear cover (Para. 5-14).
12. Service the engine (Para. 4-12).
13. Adjust the governor (speed) control shaft
(Para. 5-16).
1.
Remove the v-belt cover (Para. 4-24).
2.
Remove the gear cover (Para. 5-14).
3.
Remove the governor pin (1).
NOTE
If governor does not have to be removed
from the crankshaft, proceed with inspec-
tion and repair below. To remove gover-
nor, proceed with steps 4 and 5.
4.
Secure the flywheel to prevent turning.
CAUTION
The threads of the governor are left-
handed, size M12, and must be installed
with loctite. Considerable force may be
required to break the governor loose.
Damage to the governor may result if
turned in the wrong direction.
5.
Using a 14 mm deep socket, remove the gover-
nor (8) by turning clockwise, ensuring that the
socket is fully engaged on the hex of the gover-
nor.
5-49
